Briteq Spectra 3D Laser Manual do Utilizador descarregar pdf (Página 6)

ENGLISH USER MANUAL

BRITEQ

4/68 SPECTRA 3D LASER

3. DISPLAY: shows the selected DMX address when the unit is in DMX-mode. Apart from DMX-mode you

can also select 4 other working modes, see further to learn more

about these modes.

4. INTERNAL MICROPHONE: The built-in microphone is used to

synchronize the laser show to the beat of the music.

5. INTERLOCK input: used to connect the optional emergency stop

switch (see picture). When you push this switch the laser beam will

disappear immediately.

IMPORTANT! For your own safety we strongly recommend to

connect this optional switch!

THERE WILL BE NO LASER OUTPUT WHEN THE INTERLOCK

INPUT IS NOT USED!

Temporary solution: install the spare connector on the laser. (see picture)

6. ON/OFF KEY ACTIVATED SWITCH: used to switch the unit on/off. Use the keys

to make sure only a skilled operator is able to switch the laser on.

7. MAIN ON/OFF SWITCH: used to switch the unit on/off.

8. MAINS INPUT: with IEC socket and integrated fuse holder, connect the supplied

mains cable here.

9. EARTH CONNECTION

10. DMX OUTPUT: 3pin female XLR-connector used to connect the LASER with the next unit in the DMX

chain.

11. DMX INPUT: 3pin male XLR-connector used to connect universal DMX-cables. This input receives

instructions from a DMX-controller.

12. CONTROL PANEL: Used to select the different functions of the laser, see further to learn how to

operate the unit.

 FUNC: used to browse the different functions and working modes in the menu

 UP: used to go to the upper option or to increase a parameter of a function or working mode

 DOWN: used to go to a lower option or to decrease a parameter of a function or working mode

 ENTER: used to confirm your setting/selection

13. ILDA INPUT: used to connect the laser to an ILDA certified interface of a computer, see further for more

information.

14. COOLING FAN: used to cool the components inside the enclosure. Make sure to never cover this fan

outlet + never cover the small air inlets that are situated on the left and right side of the unit! Take care to

clean the air inlets and fan when needed.

DESCRIPTION FRONT PANEL:

15. LASER OUTPUT: the laser beam exits the enclosure, make sure to NEVER look inside the unit through

this opening while the laser effect is switched on!

16. POWER LED: indicates that the unit is switched on.

17. MUSIC LED: flashes to the sound of the music detected by the internal microphone.

1 2 3 4 5 6 7 8 9 10 11 ... 71 72

Sem comentários

Briteq Spectra 3D Laser Manual do Utilizador Página 6